Production process Antaris
Productieproces van een Antaris sloep
Altijd al willen weten hoe een Antaris sloep wordt gebouwd? Alle sloepen worden bij ons in eigen beheer gebouwd. Wij geven u graag een kijkje op onze werf in Woudsend en polyester fabriek in Zwaag door middel van deze foto’s.
For the production of the hull, we use moulds in our polyester factory in Zwaag:
The mould is first fully cleaned and degreased. The mould is sprayed in the correct colour of gelcoat. The open mould is filled with resin and small pieces of fibreglass using a spraying machine. Right after the resin and fibreglass is sprayed on the mould, all the air is rolled out of the mould with a roller to press out the air. It is important that the polyester has the right thickness, which is why a so-called polyester comb is used to measure whether the hull has the same thickness everywhere. After that the casco is laminated When the product is ready, the mould can be unloaded. Air is injected between the mould and the product and the hull is lifted out of the mould. Finally, the parts are sanded and cleaned. Vacuum injection is used for smaller parts. Glass mats and/or glass fabrics are placed on the mould, after which the mould is closed with a counter mould. By means of vacuum or pressure -or a combination of both- the resin is then pressed into the mould.
The hulls are then transported by our own means to the production hall in Woudsend. This is where the next steps in the production process of the Antaris sloop are taken:
First, the boat is brought to the antifouling department. Here the hull is sanded, degreased and put in primer and antifouling. Then the technical parts are assembled in the hull, including the motor, the propeller shaft, the bilge pump, the batteries and so on. In the meantime, the synthetic teak floor and details are put into the deck and the wiring for the lighting, among other things, is installed. In the models with cabin, the interior is made to measure in the wood department and finished in the boat. After this, the hull and deck are glued together, this is also called ‘the marriage’. After the deck and hull have been joined, the last parts are neatly sealed. The motor box and the steering console are placed and the latest technology is installed. Now the boat is ready to be tested in the water. Our experienced technicians configure the latest settings and ensure that everything works as it should. This also includes a brief trial run Finally, the boat goes to the finishing department, where the boat is completely cleaned. The cushions, bimini and spray hood are also attached. All ready for delivery!